+254 717 060 009 +254 796 000 247 (WhatsApp) info@qualitymineralssezltd.com
QUALITY MINERALS SEZ LIMITED

Blog · 15 October 2026

What D50 and D97 actually tell you

Two numbers on every calcium carbonate data sheet decide most of how a grade behaves. Here is how to read them.

Open any calcium carbonate data sheet and two numbers sit near the top: D50 and D97. Together they tell you most of what you need to know about how a grade will behave in your process.

D50: the median size

D50 is the median particle size. Half the particles, by volume, are finer than this figure and half are coarser. It tells you how fine a grade is overall. Our QM 2 has a D50 of 2.5 microns; QM 19 has a D50 of 10.

D97: the top cut

D97 is the size that 97% of the particles fall below. It describes the coarse end of the powder, and in many processes the coarse end is what causes trouble: a hole in a thin film, a weak point in a pipe, a gritty patch in a coating.

Reading them together

Two grades can share a D50 and still behave differently. QM 2 and QM 2 EX both have a median of 2.5 microns, but QM 2 EX has a top cut of 11.5 microns against 10 for QM 2. The gap between D50 and D97 tells you how tightly a grade is controlled.

A third number helps: the share of particles finer than 2 microns. The higher it is, the more very fine material the grade carries, which matters for gloss, opacity and film work.

The short version

  • D50 tells you how fine a grade is
  • D97 tells you how coarse its coarsest particles are
  • The gap between them tells you how tightly it is made

More from the blog

All articles

Tell us the grade and the tonnage.

You get a price, a lead time and a technical data sheet. No runaround.

WhatsApp us