+254 717 060 009 +254 796 000 247 (WhatsApp) info@qualitymineralssezltd.com
QUALITY MINERALS SEZ LIMITED

Blog · 14 October 2026

Choosing a calcium carbonate grade for PVC pipe

Pipe and fittings ask more of a filler than most products. What to look for, and which of our grades fit.

PVC pipe and fittings use a lot of calcium carbonate, and they ask a lot of it. The filler has to lower cost without weakening the pipe, and it has to run the same way through the extruder every day.

Start with the top cut

Impact strength in rigid PVC improves as particles get finer, and it suffers when a few oversize particles get through. For pipe, look at D97 as closely as D50. A grade with a tight top cut gives you headroom on impact tests.

Then moisture

Water in the filler turns to steam in the extruder. Look for a moisture figure you can trust; ours is 0.2% maximum ex works on every grade.

Then consistency

Steady torque and amperage on the line come from a filler that behaves the same in every bag. Ask for the data sheet, then ask how each batch is tested before it is released.

Where our grades fit

  • QM 3 S: median 3.8 microns, top cut 15, for rigid pipe and profiles
  • QM 4: median 4.2 microns, top cut 18, for pipe and general extrusion
  • QM 4 S: median 4.6 microns, top cut 20, for fittings and higher loadings

Treat these as starting points. Tell us your pipe class and loading and we will recommend a grade.

More from the blog

All articles

Tell us the grade and the tonnage.

You get a price, a lead time and a technical data sheet. No runaround.

WhatsApp us